If you need additional information, write to us by email and we will make a detailed video.
1. BAT (+) - red, permanent plus (terminal 30).
2. CAN-H - orange, to digital data bus.
3. CAN-L - purple, to the digital data bus.
4. Out to blocking (-) - green, output to blocking, 0.15 A.
5. IGN (+) - yellow, ignition input, (terminal 15).
6. Buzzer (-) - gray, negative beeper output, 0.15 A.
7. GND - black, ground.
1. Connect the power supply to the device.
2. Launch the Shadow Service application.
3. Log in with your login and password that you used on the service site.
4. Go to the central tab - Devices.
5. Click "Search devices".
6. Select the desired device. If there are several devices, then after the first click on the line with the device, part of the serial number will appear, by which you can determine the desired device.
7. Go to the Firmware tab.
8. Select the Shadow device and the desired car.
9. Click the Upload button.
In this case, only 4 wires were required to install the device in the car.
If the firmware does not support digital locking functions or digital indication, then it is necessary to connect the corresponding outputs of the device.
You can configure the device as you need using a simple and clear settings interface.
- You can turn on / off the locks. Please note that the presence of a digital lock is not always available.
- Turn off the digital indication if you plan to use an external buzzer.
- Turn on the analog lock, even if the digital one is working. In this case, the digital lock will work first, and if it was somehow orbshli or it did not work correctly, then the analog one will turn on after 4 seconds.
And many other settings ...
Also, on the Monitor tab, after installation, you need to check the correctness of the display of the car statuses.
The most important status is the ignition. Check if it turns off when the engine starts and when driving a car.
If you see that some statuses do not work correctly, i.e. turn off or turn on at a time when a physical change occurs. Then you need to contact technical support.
